Thesis and PhD milestones
The PhD milestones after coursework, and how to submit your thesis.
Milestones PhD
- Comprehensive examination. You take it after completing your course credits with the minimum CPI. It is oral, and may have a written part as well. You must pass it within four months of completing your coursework (the SPGC may allow a further two months), and in any case within four semesters of first registration. The examining board has three to five SEE faculty and one member from outside the department. The examination is passed if all the members, or all but one, are satisfied. A second failure results in the termination of your PhD programme (PG Manual 8.6).
- Candidacy for the PhD degree. Once you have completed your coursework with at least the minimum CPI and passed the comprehensive examination, you are formally admitted to candidacy for the PhD. Only students admitted to candidacy can submit a PhD thesis (PG Manual 9).
- Doctoral Monitoring Committee (DMC). On your admission to candidacy, a committee is constituted comprising your supervisor and two other faculty members. The committee meets you once a year. Before each meeting, you submit a progress report to your supervisor, who submits the DMC report on Pingala by the date in the academic calendar (15 October in 2026). You cannot pre-register for the next semester without it. After your fifth year, the report is due every semester. The report form also asks for a thesis work plan within four months of your SOTA seminar, and whether you expect to give your open seminar by the ninth semester.
- State-of-the-art (SOTA) seminar. This is a general seminar in the department on the current state of research in your area. Give it within six months of passing the comprehensive. Your supervisor reports it to the DPGC convener. If additional time is required, apply before the deadline: the SPGC chairperson may extend it by up to three months, and the SPGC by up to three further months.
- Open seminar. In this seminar you present your work to faculty and students and receive comments for incorporation in your thesis. The notice must be issued at least four days in advance, and your supervisor reports the seminar to the DPGC convener. You can submit your thesis only after the open seminar, and within six months of it. In exceptional cases, this period may be extended by up to three months; thereafter, a fresh open seminar is required.
- Thesis submission and oral examination. The steps are set out below.
Thesis M.Tech and MS by Research
- Your second year is devoted mainly to thesis research, registered as SEE 699 (M.Tech) or SEE 899 (MS by Research).
- You may submit your thesis once your credit requirements are complete. Your oral examination must take place within four months of submission. If you do not appear for it within that period, your programme is deemed to be terminated (PG Manual 11.6.1.1).
Changing or adding a supervisor
To change or add a supervisor, use the request for addition or change of supervisor. It must be signed by you and the supervisors, and approved by the DPGC. After a change of supervisor, an M.Tech or MS by Research thesis may not be submitted for three months, or a PhD thesis for six months.
Submitting the thesis
These steps are for M.Tech and PhD theses. MS by Research students have a separate procedure.
- Format your thesis according to the institute's thesis preparation guidelines, and maintain a consistent format throughout. Include the signed declaration.
- Similarity check. Submit your pre-submission draft on Pingala (Academics, then Thesis Processing Cell, then PPD Processing Form/Approval). Your supervisor then forwards it to the Plagiarism Prevention Desk; the check begins only after it has been forwarded. Allow at least two to three working days. Questions go to ppd_doaa@iitk.ac.in at the Thesis Processing Cell. The similarity index must be below 10%. If it is higher, your supervisor may certify that it cannot reasonably be reduced further. No thesis is accepted without the clearance form.
- Examiners. Your supervisor sends the list of examiners to the PG Section, signed by the DPGC convener and the Head. For an M.Tech thesis it goes to mtech_thesis@iitk.ac.in and must be approved at least 7 days before submission. For MS by Research it goes to mtech_thesis2@iitk.ac.in, and for a PhD to phd3@iitk.ac.in (PhD Desk-3, which looks after SEE).
- Upload the thesis, the synopsis and the signed processing form at oag.iitk.ac.in/studoaiitk. PhD students also upload the declaration. Keep the PDF under about 12 MB. Finally, submit the signed certificate for your student file.
Academic integrity
The Senate's code of conduct treats any use of unfair means, including plagiarism, as a violation. An instructor can bar a student from an exam, or fail them, for academic dishonesty, and the penalties can go as far as dismissal (Senate Manual, Ordinance 9). Possession of a mobile phone or any other electronic device in an examination hall results in cancellation of the examination and disciplinary action (DOAA office order, September 2025).
Every thesis includes your signed declaration that it is free of plagiarism. Before submission, the Thesis Processing Cell runs a similarity check on it through Pingala; the report is not shared with your examiners. The Cell says the institute's own plagiarism guidelines are still being written, and until they are ready it recommends the UGC's 2018 regulations.
PhD procedureM.Tech procedureMS by Research procedureDMC report form
- Maintain a dated research log or laboratory notebook from your first week. It will be required when you write your thesis.
- Back up your data and code in at least two locations, at least one of them other than your laptop.
- Use a reference manager from the outset, and record your methods and results as the work progresses rather than at the end.
- Agree on authorship with your supervisor before writing a paper.
- Run the similarity check on a near-final draft, allowing time to address its findings.
Rules last reviewed October 2026.